Universal 16-channel KNX relay actuator with the possibility of using as a curtain/blinds actuator. Powerful relays capable of switching high starting currents are used as relays. Manual control. Selective control blocking. Convenient selection of any combination of channel pairs to control curtains/blinds. Thanks to the bistable relays, the module is powered via the KNX bus.
Relay 16-channel KNX actuator with manual control. It contains bistable relays designed for an operating current of 16A and high starting currents. It is installed on a DIN rail. The width of the device is 8 DIN.
On stock
Universal 16 channel KNX relay actuator with the possibility of using as a curtain/blinds actuator. Powerful relays capable of switching high starting currents are used as relays. Manual control. Selective control blocking. Convenient selection of any combination of channel pairs to control curtains/blinds.
- Powered by KNX bus
- 16 independent high-power load control channels or 8 curtain/louver control channels
- Indication of the status of each channel
- Manual switching of each channel
- Saving the state in case of a KNX power failure
- Channel blocking in manual control mode
- Scenario-based automation
- Semi-automatic calibration of curtain movement time
- Accounting for the phase of smooth acceleration of curtains
| Device function | Building automation and home automation | |||
| External power supply | No required | |||
| Operating temperature | 0°C .. +55°C | |||
| Storage temperature | -20°C .. +55°C | |||
| Humidity during operation | 5..95% | |||
| Storage humidity | 5..95% | |||
| Flammability class (1,5 mm) | UL94 V0 | |||
| Additional Features | Class B | |||
| Protection class/Overvoltage category | II/III (4000V) | |||
| Operation mode | Continuous | |||
| Type of device action | Type 1 | |||
| Working time under load | Long | |||
| Degree of protection/Degree of contamination | IP20/2, in a clean environment | |||
| Installation |
A separate device is mounted on a DIN rail (EN50022) in an electrical cabinet |
|||
| A minimum gap between the devices | not required | |||
| Response to a KNX power failure | Saving data according to parameterization | |||
| KNX Power recovery response | Data recovery according to parameterization | |||
| Indication of operating modes |
The KNX programming indicator. In programming mode, the indicator lights up red. |
|||
Application program ETS5.7 / ETS6 (EN) – by request info@atrel.ru
