Garage door drive interface, KNX

A remote control unit for Hormann garage door drives via a KNX bus with the ability to connect various remote sensors for garage gas pollution and monitoring exceeding limit values. It is installed on a DIN rail, wall, ceiling.

Compatible Hörmann drives:

Drive	Note	The position of the “Series” switch
ProMatic 4 / SupraMatic 4		4
Liftronic 700-2 / Liftronic 800-2
ProMatic 3 / Liftronic 500		not supported
SupraMatic 3 / SupraMatic HT3 1	The serial number ends in “D”, “E”, “F”	3
LineaMatic /  LineaMatic 2
RotaMatic / RotaMatic 2
VersaMatic
WA 300 R S4 / WA 300 S4

Specifications

• Transmitting the gate status to the KNX bus
• Opening, closing, switching to ventilation mode
• Control of gates that are forgotten for a long time in the open position
• Sound notification of various emergency situations
• Connection of up to 2 garage gas sensors (exhaust gases, methane, propane, carbon dioxide)
• Monitoring of excess gas content in the room (if sensors are connected)
• The possibility of switching to ventilation mode when the maximum gas concentration is reached (if there is an appropriate sensor).
• The function of cold reset of the 4th series drives in case of loss of communication (for example, after downloading the ETS application)
• Accessories for garage door drives: Hörmann

Accessories for garage door drives: Hörmann:

• The methane sensor
• The propane sensor
• Carbon dioxide sensor
• Exhaust gas sensor